AmpBenzScientist @AmpBenzScientist@qoto.org

@PawelK @lupyuen These are very different transceivers. The SX1262 might take more energy but the bandwidth is closer to dial up speeds. That's almost double the SX1276. The SX1276 looks like it's losing on all levels. The transmission is a bit more sophisticated and I will need to review the SDR readings to try to better understand what is going on here.

@lupyuen I think that's per transmission and it seems that the SX1262 does this more often. 32.768kbps vs 62.5kbps in Lora mode. These transponders are quite different from each other. I would not recommend using the BL602 as anything other than a controller for this. The transmission power would be better supplied from a battery source.
They have the same frequency deviation but the increased transmission might make it less detectable to most SDRs. The deviation is programmable and 200khz.

@lupyuen The SX1276 has a lower power usage during transmission except for PA_Boost being used. At 13dbi it typically draws 29mA while the SX1262 is 45mA at 14dbi in the higher frequency range. It's 32mA at the same strength in in low frequency.

The SX1262 with 22dbi will draw 118mA in the high frequency mode. Keep in mind that is "typical". My EVBV1.1 was using 98mA.

@lupyuen I will look into the SX1262 and SX1276 datasheets and report back if I find something and have a good idea.

@lupyuen Just got done shaving with the safety razor and I finished it by shaving with the foil shaver. I don't think I've ever had such a close shave. I still need to clean and care for the shaver. The things we do to be accepted by society.

@lupyuen I'm going to shave with my safety razor. Electric shavers are not acceptable for a proper shave. I will be away for the typical 15 minutes it takes to shave with a safety razor.

I just used a foil shaver for the first time in my life. It's more comfortable than a rotary blade shaver. The foil shaver seems to be more effective too.

Complaints: It's not a razor. I use a safety razor to shave with. It will cut very close and only requires a single pass. Actual razors will cut any length hair. This was very easy to use but it didn't work on previously missed spots. This is a better option than a rotary shaver for me. I will probably use it for touching up in between the razor shaves that normally take around 10-15 minutes.

In conclusion, I will continue to bleed for an acceptable shave and have to open the razor to wash out hair after a couple strokes.

@lupyuen I don't like minesweeper irl. What are your thoughts on the SX chip problem?

@lupyuen I would say peaceful because cowards don't push boundaries in scientific advancement.

@lupyuen Sorry. I know almost nothing about your country. In the US we are essentially taught about our history, Russia/USSR and China.

@lupyuen I love China and especially under Xing pin. He's done much good for the country. I think his history shows the future of China.

@lupyuen Your country is against Chinese influence or for it? My country is both.

@anti Over my years of using Python, it has become quite odd.

@lupyuen No satellite dishes? They could mandate a mesh size for the parabolic reflector that would mitigate any potential problems for improper use.

@snow @cassidyclown Historically it was often covered up. We don't know what the natural distribution of homosexuality is. Marriage also traps one into heterosexuality. Are nearly all men homosexual? I think the answer is yes.

@darulharb If you were on Parlor then the FBI has all of your information from two sources. Enjoy having an audience.

@ripplestream Canada: We hate our own government but won't admit it because the US might hear it.

@georgia Get in a good workout with some heavy weight before bed time. It might be a good way to treat being homosexual. It just leaves the person homoerrotic and more of a metrosexual. If it doesn't help to get rid of being gay...you won't be disappointed. ;)

@lupyuen As an American I will have scary people hunt me down and put me in the back of a van if I don't abide by FCC regulations. The SX1278 is the only one I can use. If I'm not mistaken it's 915mhz. I also live within rough sensor range of one of the largest Air Force Bases on the East Coast in the US.

@PawelK I don't hate Hackaday, I like their hardware reviews but find most of their information to be rather useless. They have to sell more Raspberry Products and get add revenue. 2600 is entirely funded by the community. There are no real ads.