Show newer

Does anyone know if it is normal for a C64 to produce sharp notes? This should be A4 @ 440 Hz, but it is high. (All the notes are sharp.)

This is generated with an ArmSID and Qwertuoso.

James boosted

Progress on the Feather Op Amp Lab: a (low speed) analog waveform display! Same comparator circuit from last week, but now in addition to visualizing the output on an oscilloscope, we can display it on the OLED. Here we see a 1 Hz sine wave from the DAC on OA0's output pin. Then we move to channel 1 to see the square wave, which is the comparator's output. Finally, we can see how adjusting the ratio of the resistors in the ladder affects the duty cycle — both on the scope, and on the Feather!

James boosted

After watching this video I feel like foraging for pine resin to make soldering flux! youtu.be/1piQpi00d-A

James boosted

I really liked the juxtaposition of fleece fabric with 3D printed meshes from my rainbow fish project printed, so I'm now working on making a soft-sided icosahedron with a grid of 3D printed triangles on each side (to be illuminated ofc) It's required a LOT of hand sewing to securely attach the 3D printed meshes to the soft icosahedron sides, but there are now only two left to go before I can start installing the LEDs.

James boosted

I'm most excited about the light/siren combo.

I plan to remove BT/Audio circuit from an old speaker and adapt it to the siren/horn.

Then maybe VU-sensitive lights? Or just something that turns on via internet stuff?

Show thread

Here are some of the things I picked up last weekend at Hamvention ... These will become parts of future projects. (Really! ... probably.)

bald.ee/hamvention2023

James boosted

Total Replay v5.0 is out. It features 484 Apple II games (182 new since v4), all playable from a single bootable 32MB hard disk image.

archive.org/details/TotalRepla

Code: github.com/a2-4am/4cade/releas

Thanks to @a2_qkumba, @txgx42, @helix_nrg, Andrew Roughan, Frank M., Kris Kennaway, @ladyailuros, and everyone else who contributed to this project in the past four years.

#AppleII #retrocomputing

James boosted

Also, this little guy was on a table near the entrance.

A few pictures from CoCo Fest 2023 in Carol Stream, IL. (Very close to Chicago)

James boosted

Teardown is back! It's an awesome conference for hacking, discovering, and sharing hardware,
June 23 - 25, 2023, in Portland, Oregon crowdsupply.com/teardown/portl #Portland #PDX #PortlandOregon #Teardown2023 #CrowdSuppy #HardwareHacking

James boosted

Ooh! PSA: Teardown tickets sales have now started! There are still some reduced early bird tickets left, but they won't last long.

It's the first year I'll be organizing it instead of just attending! Portland is stunning in the summer: come hang out and hack with us ✨

crowdsupply.com/teardown/portl

Check out this Pi Pico development board an e14 community made (and then sent me!)

It has some nice features. The board files are available to get your own.

youtube.com/watch?v=-Kv5MwaRqb

James boosted

So, eventually, I could that Call A.P.P.L.E has an old software list that contains a disk image of the "Basic Connectivity Set." Which contains a bunch of System 7 tools and a single System 6 INIT.

But, ClarisWorks still says the toolbox isn't installed, even with that INIT.

Then. I found out that Zterm doesn't rely on it.

So, that gets me where I was going.

Show thread

Where do you get Communications Toolbox for System 6?

Replaced spinning rust platters with @BlueSCSI.

And now I can get to important work.

(This is not the Macintosh with the bombed logic board.)

Show older
Qoto Mastodon

QOTO: Question Others to Teach Ourselves
An inclusive, Academic Freedom, instance
All cultures welcome.
Hate speech and harassment strictly forbidden.