🇳🇱
So a while back i realized you can create an extremely high energy hot plasma in the microwave consistently by taking a coil and streching it out and forming it into a loop with one gap on the sad. The ark that forms has huge amount of energy in a very small space. In the past it has melted a blob of borisilicate glass almost instantly fuzing the coil i to the glass under neath.
It has a tendency to grow into a large cloud of blasma that rises to the top of the microwave usually. Since this ball plasma is much larger the energy is spread out. Despite still being extremely hot its nowhere near the heat of the initial ark as it takes some time to heat glass to its melting point in this state.
So i had an idea. What would happen if i contained the arc under a pile of salt, in this case potassium salt. It should keep the plasma contained and due to maintaining a very small volume should retain the enormous heat i figured it would be more than hot enough to melt the salt but i wanted to try it out.
Attached is the video in the microwave itself. I will reply to this thread with various stills before and after of the setup showing the final results
@Science Here are pictures of me preparing the coil, then placing it in a 30ml beaker and covering it with salt. Few notes
1) I know it looks like a resistor, it isnt. Its a 0 ohm resistor so just the same as some wire.
2) I put a layer of salt down, then the spark gap coil then a layer of salt
3) The salt is potassium chloride because it has very fine grains.
@Science Here we can see in this run (second run not the one in the video) that the arc fomed a solid clump of salt around where the arc took place as well as a half-circle of solid sald at the bottom. The half-circle of solid salt at the bottom was fused to the clump that surrounded the location of the arc. It was impossible to get it out as one piece.
The important part to notice here is that the arc traveled through the solid (or rather molten at the time the microwave was going) salt and tried to find a path to ground. It was so powerful that it instantly cracked the lab-quality beaker it is held in and you can see a crack right at the same spot the paper bowl is burnt.
Amazing it went right through the glass like it was there.
@Science Finally I took apart the solid clumps to get a closer look. At first the two pictures are the solid clumps around the spark gap pretty much in tact. They were quire hard. Howeve however I noticed when i broke it in half (as well as the solid clump at the bottom of the beaker) it was in fact hollow in the middle and only the outside was solid.
It would appear the plasma has so powerful it vaporized the salt to a gas in the middle and only the area outside the path of the arc was solid. That is one hell of a plasma arc!
@freemo strangely enough we used to do this with grapes as kids. You can cut them almost in half with a small sliver of skin connecting them and it will create plasma when microwaved.
@JohnCheathem yea grapes work but not nearly as well as a simple coil... the resistance of the grapes results in, I suspect, a much lower energy einitial discharge. The larger plasma that forms after that is likely similar to other methods of forming it.
In my method by using a small coiled wire all the energy exists in a tiny 1mm arc (initially) which has tramendous energy/heat to it as we have seen.
@freemo what happens if you have many 1mm gaps? Would the power be spread out or would it increase?