Hmmm odd... Where do we specify the firmware to be flashed 🤔
Found the #BL602 Firmware to be flashed
#BL602 Device Tree that gets bundled into our firmware before flashing over UART 🤔
How #BL602 Firmware Files are transformed before flashing
https://github.com/bouffalolab/BLOpenFlasher/blob/main/flash_tool.go
While resting my hamstring ... Let's sketch the #BL602 Firmware Flashing Steps!
https://github.com/bouffalolab/BLOpenFlasher/blob/main/flash_tool.go
Documenting the steps for Flashing #BL602 Firmware to #PineCone @PINE64
https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md
#BL602 Partition Table ... Tells us the ROM Layout
https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md
#BL602 EFuse Config ... With dead beef 😂
https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md
Can we flash #PineCone #BL602 ... From Arm64 #Pinebook Pro? Let's find out!
https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md
#PineCone #BL602 responds to #Pinebook Pro at 2 Mbps ... So far so good!
https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md
@lupyuen Heh, the last time I ever saw baud rates mentioned was like the 80's, 90's... 2400 baud modems and all that fun stuff to dial into BBSes with.
Ye gods, that was slow.
@trinsec Well with Embedded HW, going slow is usually more reliable 😉
Flashing #PineCone #BL602 from #Pinebook Pro ... Fails with the same error that was previously reported ... Will retry with lower baud rate
https://github.com/bouffalolab/BLOpenFlasher/issues/2