Experimenting with I2C on #PinePhone
https://dev.to/pcvonz/i-c-on-the-pinephone-5090
Probing the #LoRa Backplate for #PinePhone ... With Bus Pirate π€
https://wiki.pine64.org/wiki/Pinedio#Pinephone_backplate
#LoRa Backplate for #PinePhone @PINE64 is ingenious! Semtech SX1262 with an I2C-To-SPI Bridge (ATtiny84)
Probing the #PinePhone #LoRa Backplate ... Will this work? π€
Almost ... Grrrr
@lupyuen I would solder bare thin wires (copper strands) to the pads, snip them off at a few millimetres, then use ez hooks to connect.
@modrobert Yep that should work π
@lupyuen @modrobert Yes, and I even loop the thin wire back to the pad, so that the hook can't slid off. If pad is too tiny, then loop back the end and solder to itself.
QOTO: Question Others to Teach Ourselves An inclusive, Academic Freedom, instance All cultures welcome. Hate speech and harassment strictly forbidden.
@lupyuen @modrobert Yes, and I even loop the thin wire back to the pad, so that the hook can't slid off. If pad is too tiny, then loop back the end and solder to itself.