Show newer
Thanks everyone for 500 followers! Really blessed and humbled.

Crazy number since there are others posting way better content than me who have fewer followers than I do

Never had the "distributed" bit... but it actually is quite enjoyable!

@lupyuen

"(Singaporeans) aged 30 and above will be able to walk in to any of the nine Moderna vaccination centres for their booster dose"

channelnewsasia.com/singapore/

@lupyuen @modrobert Yes, and I even loop the thin wire back to the pad, so that the hook can't slid off. If pad is too tiny, then loop back the end and solder to itself.

@lupyuen I would solder bare thin wires (copper strands) to the pads, snip them off at a few millimetres, then use ez hooks to connect.

@lupyuen this is what I was going to suggest, but the putty farther down. In fact. if you put it so far down only a mm or so of the wire leads produce from the bottom it should be able to rest on top comfortably. A low center of gravity plus less wire length so less bending I think should do the trick.

Honestly I'm surprised you dont just have a 2x row header you could use instead.

Show older
Qoto Mastodon

QOTO: Question Others to Teach Ourselves
An inclusive, Academic Freedom, instance
All cultures welcome.
Hate speech and harassment strictly forbidden.