Lup Yuen Lee 李立源 @lupyuen@qoto.org

"blflash" works OK on Windows for flashing #PineCone #BL602 firmware

https://lupyuen.github.io/articles/flash

How we Flash #RISCV Firmware to #PineCone #BL602 @PINE64 ... With the #RustLang "blflash" tool by @spacemeowx2

https://lupyuen.github.io/articles/flash

#PineCone #BL602 in Holding Pattern ... Waiting to be flashed ... Jumper IO8 set to H

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

Beautiful Boot Screen from #BL602 #RISCV SoC showing its #WiFi capability ... Firmware located here:

https://github.com/bouffalolab/BLOpenFlasher/blob/main/bl602/bl602.bin

Irresistible #PineCone #BL602 @PINE64 ... Hope to see more #RustLang on BL602! 🙂

https://lupyuen.github.io/articles/debug

Bring an old #MacBook back to life with #Linux

https://opensource.com/article/20/12/linux-macbook

Good Electronics is a terrible thing to waste 🙂

Repurpose a cheap Zynq z7010 #FPGA Crypto-Miner

https://embed-me.com/ebaz4205-recycle-a-cheap-crypto-miner-part-1/

Automated conversion from #RaspberryPi to USB OTG #Webcam

https://github.com/geerlingguy/pi-webcam

#PineCone #BL602 can be flashed on #Pinebook Pro with the #RustLang "blflash" tool yay!

https://github.com/spacemeowx2/blflash

#IoT Dev Board with AVR or PIC MCU, WiFi module

https://www.cnx-software.com/2020/12/29/iot-development-board-comes-with-avr-or-pic-mcu-wifi-module/

Nope lowering the buad rate to 9600 doesn't work ... Let's reverse engineer the #GoLang #BL602 Flashing Code and see what it's doing 🤔

Flashing #PineCone #BL602 from #Pinebook Pro ... Fails with the same error that was previously reported ... Will retry with lower baud rate

https://github.com/bouffalolab/BLOpenFlasher/issues/2

#PineCone #BL602 responds to #Pinebook Pro at 2 Mbps ... So far so good!

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

Can we flash #PineCone #BL602 ... From Arm64 #Pinebook Pro? Let's find out!

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

Programming the Sipeed #BL602 EVB using OpenOCD, GDB and #RustLang

https://kvrhdn.dev/blog/programming-the-bl602-evb-using-openocd-gdb-and-rust/

Top Contributor in Singapore? 🤔 This happens when we use GitHub Pages as a Static CMS for Publishing Articles

https://commits.top/singapore.html

Build a #LiDAR with #Arduino
https://www.instructables.com/Project-Lighthouse-360-Mini-Arduino-LiDAR/

#BL602 EFuse Config ... With dead beef 😂

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md